Tools & materials needed:

• Adjustable wrench
• Pipe cutter or hacksaw
• Plumbing tape
• Flexible supply lines or tubing
• Bypass valve (if not pre-installed)
• Bucket & towels

Step 1: Choose the installation location

• Install the softener close to the main water supply line.
• Ensure it’s near a power source and a drain for backwashing.
• Avoid placing it in direct sunlight or extreme cold temperatures.

Step 2: Shut off water supply

• Turn off the main water supply.
• Open nearby taps to relieve pressure in the pipes.

Step 3: Cut & prepare pipes

• Cut the section of pipe where the softener will be installed.
• Smooth the edges using sandpaper or a pipe reamer.

Step 4: Connect the bypass valve

• Attach the bypass valve to the softener if it’s not pre-installed.
• Ensure the valve is in bypass mode before proceeding.

Step 5: Connect the water softener

• Attach the inlet and outlet connections to the main water line.
• Use flexible supply lines or tubing for easier installation.
• Apply plumbing tape to ensure leak-free connections.

Step 6: Connect the drain line

• Attach the drain hose to the softener’s drain port.
• Ensure the hose leads to a drain, keeping it secure and kink-free.

Step 7: Add salt & start the System

• Fill the brine tank with high-quality softener salt.
• Plug the unit into a power source.
• Set the settings and water hardness level according to the manufacturer’s instructions.

Step 8: Flush & Test the system

• Slowly turn on the water supply.
• Check for leaks and tighten connections if needed.
• Run a manual regeneration cycle to ensure proper function.

Final checks & tips:

• Ensure the bypass valve is in the correct position.
• Monitor for leaks over the next 24 hours.
• Periodically check salt levels and replenish as needed.

Congratulations! Your water softener is now installed and ready to provide softened water throughout your home. If you encounter any issues, refer to the manufacturer’s manual or contact customer support for assistance.